Grin's Pedal Assist sensors are transitioning to the HiGo 6 pin standard. This cable, included with all our torque sensors, effectively connects HiGo 6 pin PAS/Torque Sensors to the CA3 PAS input. It has an end - to - end length of 120cm. For situations where the PAS/Torque Sensor is far from the CA3, like in tandem bike setups, HiGo 6 extensions are available. It's also handy for linking Grin All - Axle Rear Motors to Cycle Analysts.

To use this cable, first identify the HiGo 6 pin on your PAS/Torque Sensor and the CA3 PAS input. Connect one end of the 120cm cable to the sensor and the other end to the input. If your sensor is far from the CA3, you can use the available HiGo 6 extensions. When using it to connect Grin All - Axle Rear Motors to Cycle Analysts, just make sure the connections are secure. Keep the cable away from sharp objects to avoid cuts. Regularly check the connections to ensure they are tight. If you notice any damage to the cable, replace it right away.